Jandy ePump / VS Plus Pumps
Connecting the Jandy ePump requires connecting the wires from pins 2 and 3 (black and yellow) from the supplied Jandy...
- Home
- jandy
-
-
Jandy VSFloPro Pumps
Disconnect the Pump Display/Controller Before attempting to wire the pump to The Attendant, you’ll need to remove the Local Controller... -
Jandy AquaPure/TruClear Salt Water Chlorine Generator
Ports to connect to on The Attendant: Bus 1 – 4 The Jandy AquaPure requires voltage to be supplied in... -
Water Level Sensors and Probes
Jandy/Zodiac 2-Prong Low Level Sensor This type of sensor consists of two large stainless steel probes positioned at the water... -
Jandy Infinite WaterColors LED Lights
Connecting and operating the Infinite WaterColors drivers and lights to The Attendant is easy and straightforward. You will need to... -
Jandy JXi, JXiQ, JRT, and JE Heaters and Heat Pumps
Overview The Jandy JXi Series heaters can be controlled by The Attendant using either a Serial RS-485(BUS) connection (recommended) or...