Ports to connect to on The Attendant: BUS1 – BUS4
Ports to connect to on The Attendant Mini: BUS1 – BUS2
Connecting the Jandy ePump requires connecting the wires from pins 2 and 3 (black and yellow) from the supplied Jandy ePump connector to the D+ and D- lines on one of the four communication bus terminals on The Attendant controller (labeled BUS1 through BUS4). For reference, typically the black conductor is the positive and the yellow conductor is the negative.
Set DIP switches #1 and #2 to OFF in order to allow automation system communication.
Pump address (bus identifier) is configured using switches #3 and #4. Please configure the desired address using the table below. If you have more than one pump connecting to a single bus port each pump must have a unique address.
